Rocker Guards Fits Comp/Stretch Cut Corner Guards for Jeep TJ - Notched for Motobilt TJ Front Fenders Motobilt

The Motobilt Jeep TJ Rocker Guards for competition or stretch cut corners are in-house laser cut from 3/16 inch high strength steel.Our rocker guards are formed so that they wrap under neath the body of your jeep and tie into the factory body mounts. They completely cover the front and the back past the wheel well opening.

We also slot the lower portion of the rocker guards to make it easy to clean out your rockers after a hard day of wheeling. Motobilt Jeep TJ Rocker Guards are countersunk and ship bare metal with hardware included.

Features:

• Jeep TJ Rocker Guards for competition or stretch cut corners.
• Extends past the factory wheel well opening 1 3/4 inches.
• 2 Inch wheelbase stretch or more required.
• Laser cut from 3/16 inch high strength steel
• Hardware 12 5/16 inch counter sunk bolts with flat washers and nyloc nuts.
• The proper drill size for the 5/16 inch Rivnuts is 17/32 Inch.
• Hardware included. Nut serts are only used where the nut is not accessible from the backside.
• Works with or without a body lift.
• Sold as pair
• Weight: 65lbs

Compatible Corner Guards:

• MB1057 Blank Corner Guards
• MB1051 Comp Cut Corner Guards
• MB1051-A Aluminum Comp Cut Corner Guards
• MB1127 Comp Cut Highline Corner Guards
• MB1058 4 Inch Stretch Corner Guards

Note:

• This extra length when used with the Motobilt comp cut (MB1051) or stretch cut corners (MB1058) allows for a more proportional look and additional protection
• Drill Bit Size: 5/16 Inch nut serts use a 17/32 Inch drill bit to install.
• Ships raw steel. Must be painted or powder coated to prevent rust
• Please test fit all of your Motobilt products before you paint them